...
Charge for 24 hours before undertaking commissioning using the supplied MicroUSB lead.
To turn on, insert a pin into the small hole on the right hand side of the device. Wait for the red light on the front of the device to flash and then tap again.
The top light will now go green and then slowly flash green.
To turn off, insert a pin in the small hole and hold until both lights go off.
Line Drawing
...
Manual Switching
Switch On
Press pin in small hole once, red LED illuminates briefly.
Press again, green LED illuminates briefly.
| Info |
|---|
See LED Statuses section for more detail |
Switch Off
Press pin in small hole once, red LED illuminates briefly.
Press again, green LED goes out.
| Info |
|---|
It is not normally necessary to manually switch the device off unless it will not be used for several weeks. |
Charging
Switched On
Unit is charged by connecting to a USB port in a PC or charging socket.
Slow Charge (100 mA) - Green LED flashes twice every 2 seconds.
Fast Charge - Green LED flashes three times every 2 seconds (*).
Fully Charged - Green LED is ON and stops flashing.
| Info |
|---|
From v.3.121 onwards charging will always use the full capacity of the charger. Therefore, do not use with a USB 1 socket in a laptop/PC as this could damage the USB socket. |
| Info |
|---|
(*) No longer applies from v.3.121 onwards. |
Switched Off
No charging takes place if the device has been manually switched off.
LED Statuses
Status | Activity | |
Green LED | Off | Manually switched off or in standby |
2 flashes | Charging at 100 mA | |
3 flashes | Charging at 500 mA | |
10 second flash | Fully charged in standby (*) | |
1 second cycle | Running on internal battery | |
On | Fully Charged and Active | |
Red LED | 4 second flash | Running on battery but battery getting low. |
10 second flash | Asleep and battery getting low (*). |
| Info |
|---|
(*) No longer applies from v.3.121 onwards. |
Standby Mode
To Wake Up
Move the device through more than 180°. Green LED Lights.
Running On Internal Battery
Device goes back into Standby after 3 minutes If Bluetooth not connected.
Device goes into standby if no movement or activity for 15 minutes.
Plugged into USB on Slow Charge
Goes to sleep after 15 minutes without activity (allowing faster charging) (*).
Plugged into USB on Fast Charge
Stays on indefinitely.
| Info |
|---|
(*) No longer applies from v.3.121 onwards. |
Working Offline
Either switch the DONGLE off manually or:
Click the Bluetooth icon.
Click Work Offline.