Wireless ZigBee Button is a button switch which is designed for use in the Glamox Wireless ZigBee system.
No wiring and lack of power connections give wide possibilities of mounting. Installation is easy and the device does not require maintenance.
The device also does not need internal battery or any external power supply. Energy source is an electro-dynamic energy generator inside the switch.
The comfort of the usage is very high due to low mechanical force needed for pressing the buttons.
In addition to conventional ON/OFF control you can use this button for dimming the light and triggering lighting scenes.
Product page onGlamox website
LMS ZIGBEE GREENPOWER 2B
LMS ZIGBEE GREENPOWER 4B
Item requires additional frame: https://www.glamox.com/en/pbs/products/indoor/downlight/1411701/
Device features
No battery and no wiring
Distance to the first sensor has to be less than 10 meters (in a line of sight)
ON/OFF control and dimming, dimming, scene control (4B only)
Gluing or screwing onto the flat surface
| Drawio sketch | ||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Commissioning procedure
For commissioning a switch, follow steps shown in the app which are same to the diagram above.
Limitations - how to use it in the LMS design
Range: within one room (up to 10m line of sight),
Add all luminaires in a group first and then add a switch. Switch binding mechanism is to each node within the Zigbee group at the time of commissioning. If new nodes are added after commissioning, switch binding does not take place.
A switch can be added either to a group or to a zone. Once added to a zone, another switch will need to follow the same choice i.e. either a group or a zone.
Up to 5 switches can be added within a group. All switches attached within a group should belong to a single brand. Combining switches from different brands is not recommended.
In case switches are used for a group and at the same time for zones of that group, three things need to be taken into account:
The switch of the group should be added first.
Only 2-button switches should be used for the group.
In the zones 4-button switches with scene setting can be used.
It is recommended to use not more than one 4-button switch per zone.
If two or more zones are used with a 4-button switch, the maximum number of lights is 20 per zone.
In case the switch is not detected during the commissioning procedure, please re-try.
The backside of the switch may show an “O” and an “I indicator. The switch needs to be mounted such that ‘I’ is at the TOP and ‘O’ at the BOTTOM.
Do not remove the rocker from the switch module. If the rocker is placed back 180° rotated the switch does not function properly.
During commissioning of ZGP switches (in test setups) the devices should not be too close to the lights (between 2m and 5m distance) to avoid commissioning failures.