There are no parameters in the App for setting Daylight regulation. The parameter ON level Presence will is automatically be the set point for DLR.
If no calibration is performed, the light output adjusts approximately to 500 lux times the value set for the at 100% of ON level presence.
As a example if it the parameter is set to 80%50%, the light output from the luminaire adjusts to 400 250 lux on desk level.
The system will be calibrated function is working when “Daylight based control” is enabled.
...
When manually overriding the ON level presence the DLR functionality will be disabled. The DLR functionality will be enabled again when the hold time expires and or a new ON level presence command is sent.
When enabling an HCL cycle generated from a Gateway the ON level presence will change according to the light level cycle from the Gateway and this will then change the setpoint accordingly.
...
| Info |
|---|
Be aware that the DLR is based on the readings from the sensor photocell. These readings are based on reflected light from a coverage area. The reflected light from the sensors coverage area might be different from what the user experience in the room. For a precise measure please perform a DLR Calibration calibrate daylight sensor. |