Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Hardware

...

First Time Connection

...

To connect a new DONGLE to the tablet:

...

When Paired DONGLE will Automatically Connect

...

Connection Issues

If it doesn't connect:

  • Check DONGLE is On and Awake (Green LED is On or Flashing).

  • Check Mac address (beside Bluetooth icon on Tablet) matches DONGLE.

  • If Mac address is ‘None’ or different to DONGLE then re-pair as left.

Info

The Mac address of the DONGLE is on the label on the back of the device.

Manual Switching

Switch On

  • Press pin in small hole once, red LED illuminates briefly.

  • Press again, green LED illuminates briefly.

Info

See LED Statuses section for more detail

Switch Off

  • Press pin in small hole once, red LED illuminates briefly.

  • Press again, green LED goes out.

Info

It is not normally necessary to manually switch the device off unless it will not be used for several weeks.

Charging

Switched On

  • Unit is charged by connecting to a USB port in a PC or charging socket.

    • Slow Charge (100 mA) - Green LED flashes twice every 2 seconds.

    • Fast Charge - Green LED flashes three times every 2 seconds (*).

    • Fully Charged - Green LED is ON and stops flashing.

...

Info

(*) No longer applies from v.3.121 onwards.

Switched Off

  • No charging takes place if the device has been manually switched off.

LED Statuses

Status

Activity

Green LED

Off

Manually switched off or in standby

2 flashes

Charging at 100 mA

3 flashes

Charging at 500 mA

10 second flash

Fully charged in standby (*)

1 second cycle

Running on internal battery

On

Fully Charged and Active

Red LED

4 second flash

Running on battery but battery getting low.

10 second flash

Asleep and battery getting low (*).

Info

(*) No longer applies from v.3.121 onwards.

Standby Mode

To Wake Up

  • Move the device through more than 180°. Green LED Lights.

Running On Internal Battery

  • Device goes back into Standby after 3 minutes If Bluetooth not connected.

  • Device goes into standby if no movement or activity for 15 minutes.

Plugged into USB on Slow Charge

  • Goes to sleep after 15 minutes without activity (allowing faster charging) (*).

Plugged into USB on Fast Charge

  • Stays on indefinitely.

Info

(*) No longer applies from v.3.121 onwards.

Working Offline

Either switch the DONGLE off manually or:

...